Cr Unit - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual
Color inkjet printer
Hide thumbs
Also See for R260 - Stylus Photo Color Inkjet Printer:
- Printer basics manual (82 pages) ,
- Supplementary manual (14 pages) ,
- Start here manual (8 pages)
Table of Contents
EPSON Stylus Photo R260/R265/R270, R360/R380/R390
7.
Remove the Combination Gear (10, 15.2), and remove the ASF Unit.
Combination
Gear
[Rear side]
Figure 4-143. Removing the ASF Unit
Lubrication is required. See the page given below for the
lubrication information.
"6.1.3 Lubrication (p.131)"
When installing the ASF Unit, make sure that the Combination
Gear, tip of the Change Lever and the two hooks are securely
attached. Also make sure that there is appropriate space at
both the left and right of the Change Lever.
Tighten the screws in the order given in Fig.4-141.
Install the LD Roller following the procedure below. Make
sure to apply grease referring to the page given below.
"6.1.3 Lubrication (p.131)"
Install the LD Roller aligning the arrow on the LD Roller with
the arrow on the blade of the shaft. Make sure the LD Roller is
securely attached without gap or misalignment.
Align the arrows
Figure 4-144. Reinstalling the LD Roller
Disassembly/Assembly
Removal Direction
ASF Unit
LD Roller
ASF Unit
Blade
LD Roller Shaft
Disassembly of the Printer Mechanism
4.5.12 CR Unit
Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism / CR Scale
/ APG Unit / CR Motor / EJ Frame Assy
Removal procedure
Refer to the Orientation Definition below for the directions
indicated in the following procedures.
•
"4.1.6 Orientation Definition (p.61)"
Before turning the Parallelism Bushing L, mark the scale position
of the Parallelism Bushing with a marker. And taking extra care
not to damage the Gear with the rib, pull it toward the front.
1.
Disengage the upper end of the Spring (1) from the slit, and remove the
Spring (1).
2.
Loosen the screw (
), and turn the Parallelism Bushing L clockwise to the
maximum.
Spring (1)
Parallelism Bushing L
Figure 4-145. Removing the CR Unit (1)
Revision B
Slit
105
- Quick Links:
- Service Manual
- Printing
Hide quick links:
Table of Contents
Troubleshooting
