Exit-Overflow-Interval - Dell PowerConnect 6224 Command Line Interface Manual
6200 series systems
Hide thumbs
Also See for PowerConnect 6224:
- User manual (786 pages) ,
- Release note (34 pages) ,
- Planning and preparation manual (12 pages)
Table of Contents
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables administrative mode of OSPF in the router
(active).
console(config)#ipv6 router ospf
console(config-rtr)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPFv3 Configuration
mode to configure the exit overflow interval for OSPF. It describes the
number of seconds after entering Overflow state that a router will wait before
attempting to leave the Overflow State. This allows the router to originate
non-default AS-external-LSAs again. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
seconds
exit-overflow-interval
no exit-overflow-interval
seconds — Exit overflow interval for OSPF (Range: 0-2147483647)
•
Default Configuration
seconds
0 is the default value for
.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
950
OSPFv3 Commands
- Quick Links:
- Cli Reference Guide
- Using the Cli
Hide quick links:
Table of Contents
