Mounting The Slide Rails On The Sides Of The Switch - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Instructions Manual
Edge switch 2/24 rack mount kit installation instructions
Hide thumbs
Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
- Service manual (322 pages) ,
- User manual (300 pages) ,
- Reference manual (214 pages)
Table of Contents
Installation Instructions
Mounting the Slide Rails on the Sides of the Switch
Use these steps to install the slide rails on the sides of the switch as shown in Figure 2.
You will need a torque driver with a T10 Torx bit (not supplied in the kit) and left and
right slide rails to complete this procedure.
NOTE: You may want to remove the Edge Switch 2/24 power supplies, as this will make the
device lighter and easier to handle.
WARNING: Before removing the power supplies, review the edge switch 2/24
installation guide for details on removing power supplies.
1. On the Edge Switch 2/24, remove the six screws (three screws per side) which
help hold the switch cover in place.
NOTE: Do not discard these screws, as you will use them to attach the slide rails.
2. Using the torque driver and the screws you removed earlier, attach the left and
right slide rails to the Edge Switch 2/24.
Figure 2: Attaching the slide rail to the switch
4
edge switch 2/24 rack mount kit installation instructions
Table of Contents
