HP 300X - JetDirect Print Server Administrator's Manual page 75
Hp jetdirect print server administrator's guide (300x, 510x)
Hide thumbs
Also See for 300X - JetDirect Print Server:
- Installation and configuration manual (80 pages) ,
- Manuallines (33 pages) ,
- Hardware installation manual (30 pages)
Table of Contents
Table 7.2
General HP Jetdirect Messages (7 of 10)
Message
NOT CONFIGURED
NOVRAM ERROR
OUT OF BUFFERS
OVERFLOW ERROR
PASSWORD ERROR
POSTSCRIPT MODE
NOT SELECTED
or POSTSCRIPT
UPDATE NEEDED
PRINT SERVER NOT
DEFINED
PRINTER NUMBER IN
USE
PRINTER NUMBER NOT
DEFINED
ENWW
Description
The HP Jetdirect print server has not been configured for
NetWare. Use the printer installation software to configure
the print server for NetWare networks.
The HP Jetdirect print server cannot read the contents of
its NOVRAM.
The HP Jetdirect print server was unable to allocate a
buffer from its internal memory. This indicates all buffers
are busy due possibly to heavy broadcast traffic or large
amounts of network traffic directed to the print server.
Run the power-on self-test: turn the print server off, then
on again.
The HP Jetdirect print server detected that the password
for the NetWare print server object is wrong. Use the
PCONSOLE utility to erase the password for the print
server object. When the HP Jetdirect print server logs on
again, it sets a new password.
Note: When multiple file servers are configured, the error
is only displayed on the configuration page if none of the
file servers are connected.
The printer does not support the EtherTalk extensions. It
may be a printer which does not support AppleTalk. When
this message is displayed, the other AppleTalk messages
(ADDRESS, APPLETALK NAME, ZONE NAME) are not
displayed.
The file server does not have a print server object that
corresponds to the specified NetWare node name. Use
printer installation software or PCONSOLE to create the
print server object.
When the HP Jetdirect print server is configured for
multiple file servers, the error is only displayed on the
configuration page if none of the file servers made the
connection.
The printer number assigned to the printer is already in
use by another printer. Assign an unused printer number.
This may also occur when a printer is power cycled, in
which case the error goes away after the print server times
out and detects the lost connection.
The printer number you assigned to the remote printer has
not been defined. Assign a valid printer number to the
HP Jetdirect print server, or run PCONSOLE and define a
printer number for the print server.
HP Jetdirect Configuration Page Messages 75
Hide quick links:
Table of Contents
Troubleshooting
