HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Quick Setup Manual
Quick setup - 5967-9985
Hide thumbs
Also See for J3278B - SureStore CD-ROM Server/Tower 7 NAS Server:
- Administrator's manual (306 pages) ,
- User manual (168 pages) ,
- Manual (28 pages)
Quick Links
See also:
Administrator's Manual, User Manual
Q u i ck Se tu p
1
Locate parts
Locate the parts needed for installation:
HP SureStore
User's Guide (for
Power Cords (2)
HD Server 4000
more information)
You also need:
• A twisted-pair network cable with RJ-45 connectors (not included).
• Two power outlets.
• An IP address, subnet mask, and, optionally, the default gateway
(router). Configure them using DHCP or BOOTP, or manually at the
server control panel. See your IP administrator for this information.
4
Verify hardware installation
On the front of the server, switch on the power and
check the following:
Main power light above power switch is
on.
Power display reads HP.
Control panel display shows varying
self-test and loading messages.
Power and activity lights for all hard
drives blink indicating self-test, and
then power lights remain green.
If any of these checks fail, see chapter 11 in the User's Guide.
H P
S u r e S t o r e
N e t w o r k A t t a c h e d S t o r a g e
2
Connect the network cable
On the back of the server, attach
the network cable between the
server and the network connector
at the wall.
5
Configure IP settings
When the control panel prompts you (first two messages at left), do one of the following:
•
To set the IP settings using DHCP or BOOTP, press
Press
to use
-or-
DHCP/BOOTP or...
•
To set the IP settings manually at the control panel, follow these steps:
1. Press
2. Enter the IP address. Use
Press
to set
number and move to the next space. (Use
IP manually
the last number, press
3. Enter the subnet mask. Press
one the same way you entered the IP address. When finished, press
4. Enter the default gateway . Press
IP Address
a new one the same way you entered the IP address. When finished, press
000.000.000.000
5. Press
3
Plug in power cords
1.
Caution!
Ensure that the
voltage switches are set
correctly for your country.
1
2. Plug the two power cords into
the back of the server, and
then plug the other ends of
the cords into the power
outlets.
Caution!
If you need different power
2
cords than the ones supplied,
use power cords approved for
your country. See chapter 3 in
the User's Guide.
.
. The third message at left appears, with the first 0 blinking.
to change the blinking number, and press
to move to a previous space.) Once you set
to accept the new IP address.
. To change the subnet mask, press
and enter a new
.
. To change the default gateway, press
to exit setup mode, and then press
to confirm.
R
to select a
and enter
.
Related Manuals for HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server
Summary of Contents for HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server
- Page 1 Q u i ck Se tu p Locate parts Connect the network cable Plug in power cords Locate the parts needed for installation: On the back of the server, attach Caution! Ensure that the the network cable between the voltage switches are set HP SureStore User's Guide (for server and the network connector...
- Page 2 • Technical support updates configuration, and troubleshooting help. do this task themselves. • Special Hewlett-Packard offers See chapter 5 in the User's • Details on new products and technology Guide for more information.