1. Manuals
  2. Brands
  3. Dell Manuals
  4. Computer Accessories
  5. POWER VAULT 130T LIBRARY 130T
  6. Installation manual

Dell POWER VAULT 130T LIBRARY 130T Installation Manual

Dell computer accessories user manual
Hide thumbs Also See for POWER VAULT 130T LIBRARY 130T:

Quick Links

See also: Service Manual, User Manual
®
™
Dell PowerVault
130T Library
DRIVE INSTALLATION GUIDE
www.dell.com
loading

Related Manuals for Dell POWER VAULT 130T LIBRARY 130T

Summary of Contents for Dell POWER VAULT 130T LIBRARY 130T

  • Page 1 ® ™ Dell PowerVault 130T Library DRIVE INSTALLATION GUIDE www.dell.com...
  • Page 3 ® ™ Dell PowerVault 130T Library DRIVE INSTALLATION GUIDE www.dell.com...
  • Page 4 Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden. Trademarks used in this text: Dell, the DELL logo are registered trademarks, and PowerVault is a trade- mark of Dell Computer Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
  • Page 5 PowerVault 130T Drive Installation Instructions DLT Drive Tray Assembly These installation instructions describes how to remove, install and configure a DLT Drive Tray Assembly into the PowerVault 130T . Before beginning this procedure be sure to take note of your drive configuration. You may need this later to reconfigure your new or additional drives.
  • Page 6 Figure 1. Back Vziew of Drive Tray Assembly Back View of Drive Tray Assembly Item Parts Description Number Tape Drive Thumbscrew (3x) Hinged Door Drive Tray Assembly Conversion Instructions...
  • Page 7 Figure 2. Interface Connection and Power Interface Connection and Power Item Parts Description Number Power Receptacle Tape Drive Interface Connector Thumbscrew (2x) Disconnect the power cable from the tape drive. CAUTION: Disconnect the tape drive interface cable (P980-P983), as described in the next step, before removing the tape drive.
  • Page 8 • Verify that required cables are present. • Report any damaged or missing items to your Dell representative. WARNING: Do not touch any components on the power supply. Live voltage could be present even though the unit is powered off.
  • Page 9 Setting TermPwr Item Parts Description Number Power Supply Cover Power Supply Cover Screw Location (2x) TermPwr Jumper, second pair of pins from end of connector (shown enabled) To check terminator power (TERMPWR), remove the two power supply cover screws using a Torx driver with a T-15 bit, and lift the cover (pulling forward slightly) enough to see the jumpers.
  • Page 10 Figure 4. Connecting the SCSI cable Connecting the SCSI cable Item Parts Description Number Tape Drive Interface Cable (P983) Thumbscrew (2x) SCSI Connector (2x Per Drive) Drive 0 CAUTION: The tape drive interface cable (P980-P983) marking faces the rear of the tape drive.
  • Page 11 Close the hinged door at the rear of the library. 10. Tighten the two thumbscrews to secure the door. 11. Connect the SCSI cables and/or terminator to the SCSI connectors on the rear of the tape drive. How to Set the Drive SCSI ID If you are replacing an existing drive, you do not have to configure the SCSI ID.
  • Page 12 Scroll using the arrow buttons to select the correct drive (drives are numbered 0 through 3 starting from the bottom). A sub-menu allows you to set drives “on-bus” (the same SCSI bus asa the library or “off-bus (a different bus). This is necessary for some host software packages. The option is part of the Set Drive SCSI ID configuration routine.
  • Page 13 Printed in the U.S.A. ® 5085D...