Table of Contents
Media Setting
Media Length
Clip Default
Print Mode
Peel Strength
Label Top Adjust
Label Reset
Adjust
Media
Calibration Mode
Length (Slow
Mode)
Power Up Action
PC45 Series Printer User Guide
Description
Sets the length of the printable area measured from one
edge of the label to the edge that is closest to the
printhead. Unit of measurement is defined in the Unit of
Measurement parameter.
Media length (X)
Determines if the printer prints items outside the
printable area of the label.
When this is set to Off, the printer returns an error if any
part of a barcode label cannot be printed because that
part extends beyond the printable area. When this is set to
On, the printer prints all barcode labels, but may also print
unreadable, incomplete labels.
Selects the printer tear off, peel off, or rewind media mode
Selects strength the printer uses to peel the label off from
liner. Use Medium or High if the printer has trouble to peel
certain types of media.
Sets the length of media the printer feeds (positive value)
or retracts (negative value) before printing a label. Unit of
measurement is defined in the Unit of Measure
parameter. Range is -9999 to +9999.
Sets the length of media the printer feeds (positive value)
or retracts (negative value) after printing a label. Unit of
measurement is defined in the Unit of Measure
parameter. Range is -9999 to +9999.
Selects the mode the printer uses to calibrate media. Use
Slow if the printer has trouble identifying gaps or marks in
media. Use Fast with Retraction or Slow with Retraction to
retract the media and ribbon fed for calibration back to
the printer.
If Media Calibration Mode is set to Slow, the printer prints
the media length plus 10 mm. This value sets an
additional amount of media to be printed. Unit of
measurement is defined in the Unit of Measurement
parameter. Range is 0 to 3200.
Sets the action when you turn the printer on:
No Action
Form feed: The printer feeds one label.
Test feed: The printer prints two configuration labels as it
calibrates the media sensors.
Smart Calibration: Detects media type (gap, black mark,
or continuous, detects printing method (ribbon or no-
ribbon), and calibrates media length.
Default
1226 dots
Off
Tear Off
Low
0
0
Slow
0
No Action
87
Table of Contents
