Table of Contents
Step 3 | Change the latch bolt direction
You can change the direction of the latch bolt to adapt to doors of different
opening directions. When the bolt bevel faces out the door, it is for
outwards door opening; And when the bolt bevel faces in the door, it is for
inwards door opening.
Latch bolt
Directional
screw
Attention
1. Choose a proper installation kit based on the door thickness;
2. The default tool kit is applicable to door thickness of 38-60mm. If your door thickness is out of
this range, please contact us.
Installation steps
The following installation steps apply to right-open doors. For left-open doors,
please read the [Pre-installation instructions] carefully and make needed
adjustments.
Use the drilling template to drill
1
the needed holes on the door and
mount the mortise into the door.
6
Inverting tailpiece
1. Push the inverting tailpiece to the top.
2. Press the latch bolt down to the mortise
surface, then rotate it 180 degrees and pull it
out.
3. Push the tailpiece to the bottom.
4. Change the direction of the directional
screw according to your actual needs (the
directional screw must be installed on the
inside of the door, i.e. the inside escutcheon)
2
Tighten up the 4 fixed screws
when inserting the mortise.
Table of Contents
