Dhw Pump For Disinfection; Setting Up The Energy Metering - Daikin EPRA18DAV3 Installer's Reference Manual
Hide thumbs
Also See for EPRA18DAV3:
- Installer's reference manual (308 pages) ,
- Installation manual (40 pages) ,
- Installer's reference manual (260 pages)
Table of Contents
5.4.5 DHW pump for disinfection
5.5 Setting up the energy metering
EPRA14~18DAV3+W1 + ETVH/X16S18+23DA6V+9W(G)
Daikin Altherma 3 H HT F
4P587502-1B – 2020.12
Setup
a
a Cold water IN
b Hot water OUT (shower (field supply))
c DHW pump (field supply)
d Heater element (field supply)
e Non‑return valve (field supply)
▪
The DHW pump is field-supplied and its installation is the responsibility of the
installer. For the electrical wiring, see
4
pump" [
107].
▪
If the applicable legislation requires a higher temperature than the maximum
tank setpoint during disinfection (see [2-03] in the field settings table), you can
connect a DHW pump and heater element as shown above.
▪
If applicable legislation requires disinfection of the water piping until the tapping
point, you can connect a DHW pump and heater element (if needed) as shown
above.
Configuration
The indoor unit can control DHW pump operation. For more information, see
4
"9 Configuration" [
115].
▪
Via the user interface, you can read out the following energy data:
-
Produced heat
-
Consumed energy
▪
You can read out the energy data:
-
For space heating
-
For space cooling
-
For domestic hot water production
▪
You can read out the energy data:
-
Per month
-
Per year
5
Application guidelines
|
b
c
d
e
"To connect the domestic hot water
Installer reference guide
45
Table of Contents
