Dhw Pump For Disinfection; Setting Up The Energy Metering - Daikin EPRA18DAW1 Installer's Reference Manual
Hide thumbs
Also See for EPRA18DAW1:
- Installer's reference manual (308 pages) ,
- Installation manual (40 pages) ,
- Installer's reference manual (284 pages)
Table of Contents
5
|
Application guidelines
5.3.5 DHW pump for disinfection
5.4 Setting up the energy metering
Installer reference guide
34
For more information about connecting the recirculation connection, see
connect the recirculation
Configuration
▪
For more information, see "9 Configuration" [
▪
You can program a schedule to control the DHW pump via the user interface. For
more information, see the user reference guide.
Setup
a
a Cold water IN
b Hot water OUT (shower (field supply))
c DHW pump (field supply)
d Heater element (field supply)
e Non‑return valve (field supply)
▪
The DHW pump is field-supplied and its installation is the responsibility of the
installer. For the electrical wiring, see
4
pump" [
98].
▪
If the applicable legislation requires a higher temperature than the maximum
tank setpoint during disinfection (see [2-03] in the field settings table), you can
connect a DHW pump and heater element as shown above.
▪
If applicable legislation requires disinfection of the water piping until the tapping
point, you can connect a DHW pump and heater element (if needed) as shown
above.
▪
To ensure a complete disinfection, you have to open the tapping point.
WARNING
When opening the tapping point, the water temperature can be up to 55°C.
Configuration
The indoor unit can control DHW pump operation. For more information, see
4
"9 Configuration" [
107].
▪
Via the user interface, you can read out the following energy data:
-
Produced heat
-
Consumed energy
4
piping" [
72].
4
b
c
d
e
"8.3.5 To connect the domestic hot water
107].
EPRA14~18DAV3+W1 + ETVZ16S18+23DA6V+9W
Daikin Altherma 3 H HT F
4P587503-1A – 2020.01
"7.2.4 To
Table of Contents
