Cisco 1120 Installation Manual page 98
Secure access control server
Hide thumbs
Also See for 1120:
- Hardware installation (98 pages) ,
- Quick start manual (10 pages) ,
- Installation manual (6 pages)
Table of Contents
Recovery Management
[2] Restore hard disk image from CD
[3] Exit and reboot
Enter menu item number: [ ]
At the
Step 4
Result: The console displays:
This operation will completely erase the hard drive. Press 'Y' to confirm, any other key
to cancel: __
The next step erases the CSACS 1120 hard drive. You will permanently lose all system data that you
Caution
have not backed up.
Enter
Step 5
Result: The appliance processes the new image (this may take several minutes) while displaying odd
characters and then displays the following message on the console:
The system has been reimaged successfully. Please remove this recovery CD from the drive,
then hit RETURN to restart the system:
The reimaging process may take several minutes to complete.
Note
Remove the Recovery CD from the CSACS 1120, and press Enter to restart the appliance.
Step 6
Result: The CSACS 1120 reboots, performs some configurations, and reboots again. The
configurations that occur after the first reboot take a significant amount of time, during which there is
no feedback. This is normal system behavior.
After re-imaging the CSACS 1120 hard drive, you must once again perform initial configuration of the
Note
CSACS 1120. For detailed instructions, see
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
4-28
Enter menu item number: [ ]
, and press Enter.
Y
Chapter 4
Administering the Cisco 1120 Secure Access Control Server
prompt
enter
, and press Enter.
,
2
Configuring CSACS
1120.
OL-19455-01
Hide quick links:
Table of Contents
Troubleshooting
