Re-Imaging The Csacs 1120 Hard Drive - Cisco 1120 Installation Manual
Secure access control server
Hide thumbs
Also See for 1120:
- Hardware installation (98 pages) ,
- Quick start manual (10 pages) ,
- Installation manual (6 pages)
Table of Contents
Chapter 4
Administering the Cisco 1120 Secure Access Control Server
Step 8
Press Enter to change the default administrator account and password.
Result: The console displays:
Enter new account name:
Note
At the
Step 9
Result: The console displays:
Enter new password:
Step 10
At the
Note
Result: The console displays:
Enter new password again:
At the
Step 11
Result: The console displays:
Password is set successfully.
Note
Re-imaging the CSACS 1120 Hard Drive
Use the CSACS 1120 Recovery CD-ROM to re-image the appliance if necessary.
Caution
Performing this procedure destroys all data stored on the CSACS 1120.
To re-image your CSACS 1120:
Connect a console to the CSACS 1120 console port. For the location of the console port, see
Step 1
Put the Recovery CD in the CSACS 1120 CD-ROM drive. See
Step 2
Power on the (or, if the CSACS 1120 is already running, reboot it). For more information, see
Step 3
the CSACS 1120 from a Serial
Result: The console displays:
ACS Appliance Recovery Options
[1] Reset administrator account
OL-19455-01
Press only the Enter key at
password recovery process.
Enter new account name:
prompt, enter the new password, and press Enter.
Enter new password:
The new password must be unique and should not be identical to the last ten passwords that have
been used. It must contain a minimum of six characters, and it must include a mix of at least
three character types: numerals, special characters, uppercase letters, and lowercase letters. Each
of the following examples is acceptable: 1PaSsWoRd, *password44, Pass*word.
Enter new password again:
The user name should not be configured as administrator. If it is set so, it will lead to the faliure
of the password recovery process.
Console.
Step
8. If you press any other key it will lead to the faliure of the
prompt, enter the name of the administrator, and press Enter.
prompt, enter the new password again, and press Enter.
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
Recovery Management
Figure
1-2.
Figure
1-3.
Rebooting
4-27
Hide quick links:
Table of Contents
Troubleshooting
