Cisco 1600 Getting Started Manual

Cisco Firepower Management Center 1600, 2600,

and 4600 Getting Started Guide

First Published: 2019-06-26

Last Modified: 2022-05-31

Firepower Management Center 1600, 2600, and 4600 Getting Started Guide

The Firepower Management Center 1600, 2600, and 4600 Getting Started Guide explains installation, login,

setup, initial administrative settings, and configuration for your secure network. This document also describes

maintenance activities such as establishing alternative means of management center access, adding managed

devices to the management center, factory reset, saving and loading configurations, erasing the hard drive,

and performing shutdown or restart.

In a typical deployment on a large network, you install multiple managed devices on network segments. Each

device controls, inspects, monitors, and analyzes traffic, and then reports to a management center. The

management center provides a centralized management console with a web interface that you can use to

perform administrative, management, analysis, and reporting tasks in service to securing your local network.

About the Firepower Management Center Models 1600, 2600, and 4600

The following topics provide information about front and rear panel features that you need to follow the

instructions in this document.

Rear Panel Features

The following figure illustrates the rear panel of the Firepower Management Center 1600, 2600, and 4600.

For more information on the rear-panel features, see the

and 4600 Hardware Installation

Figure 1: Rear Panel

1

Guide.

USB 3.0 Type A (USB 1)

You can connect a keyboard, and along with a

monitor on the VGA port, you can access the

console.

Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide

Cisco Firepower Management Center 1600, 2600,

2

USB 3.0 Type A (USB 2)

You can connect a keyboard, and along with a

monitor on the VGA port, you can access the

console.

1