Cmos Board Assembly - Sony EVI-HD7V Service Manual
Hd color video camera
Hide thumbs
Also See for EVI-HD7V:
- Operating instructions manual (92 pages) ,
- Technical manual (40 pages) ,
- Brochure (8 pages)
Table of Contents
1-4-3. CMOS Board Assembly
n
When replacing the CMOS board assembly, perform the adjustment of camera in reference to Section 2.
1. Remove the side cabinet. (Refer to Section 1-2-1.)
2. Remove the front bezel. (Refer to Section 1-2-2.)
3. Remove the camera cabinet (lower front/lower rear). (Refer to Section 1-2-3.)
4. Remove the camera cabinet (upper). (Refer to Section 1-2-4.)
5. Remove the camera block assembly. (Refer to Section 1-3-1.)
6. Remove the VC-576 board. (Refer to Section 1-4-1.)
7. Disconnect the coaxial harness from the connector on the CMOS board assembly.
8. Remove the three screws (B1.7 x 3.5), then remove the camera chassis.
9. Remove the heat radiation rubber from the camera chassis.
10. Remove the two screws (PTP2 x 5), then remove the CMOS board assembly.
B1.7 x 3.5
11. To install, reverse the removal procedure.
EVI-HD7V
Camera chassis
Heat radiation
rubber
Coaxial harness
Connector
PTP2 x 5
CMOS board
assembly
1-13
Table of Contents
