Telnet - HP Enterprise FlexFabric 12900E Series Command Reference Manual
Hide thumbs
Also See for Enterprise FlexFabric 12900E Series:
- Installation manual (152 pages) ,
- Configuration manual (552 pages)
Table of Contents
Default
One stop bit is used.
Views
User line view
Predefined user roles
network-admin
Parameters
: Uses one stop bit.
1
: Uses one and a half stop bits. The device does not support using one and a half stop bits. If you
1.5
specify this keyword, two stop bits are used.
: Uses two stop bits.
2
Usage guidelines
This command is not supported in VTY line view.
The configuration terminal and the device must use the same number of stop bits to communicate.
Examples
# Set the number of stop bits to 1 for AUX line 0.
[Sysname] line aux 0
[Sysname-line-aux0] stopbits 1
telnet
Use
telnet
Syntax
telnet remote-host [ service-port ] [ vpn-instance vpn-instance-name ]
[ source { interface interface-type interface-number | ip ip-address } |
dscp dscp-value ] *
Views
User view
Predefined user roles
network-admin
Parameters
remote-host
case-insensitive string of 1 to 253 characters. Valid characters include letters, digits, hyphens (-),
underscores (_), and dots (.).
service-port
value range is 0 to 65535 and the default is 23.
vpn-instance vpn-instance-name
host belongs. The
case-sensitive string of 1 to 31 characters. If the remote host belongs to the public network, do not
specify this option.
to Telnet to a host in an IPv4 network.
: Specifies the IPv4 address or host name of a remote host. A host name can be a
: Specifies the TCP port number for the Telnet service on the remote host. The
vpn-instance-name
: Specifies the MPLS L3VPN instance to which the remote
argument represents the VPN instance name, a
73
Table of Contents
