Table of Contents
5.
Press the SELECT switch (/) (5) to select diagnoses items.
The display of the dot matrix LED is changed to any of the modes from 'Mode 00' to 'Mode 05'.
(5)
6.
Press the OK switch (6).
(6)
7.
The selected diagnostic items are run.
• Page 37 If Mode00 to Mode04 is run
• Page 38 If Mode05 is run
■If Mode00 to Mode04 is run
If Mode00 to Mode04 is run, then perform diagnoses using the following steps.
1.
During diagnosis, the MAIN LED is lit, and the diagnostic mode and its progress are displayed on the dot matrix LED.
• If Mode01 and progress 50%
2.
When diagnosis ends, the MAIN RUN LED goes off, and the diagnostic results are displayed on the dot matrix LED.
• Normal end: 'OK' is displayed on the dot matrix LED.
• Error end: the error that occurred is displayed on the dot matrix LED. ( Page 39 If diagnoses results show an error)
Diagnoses from the detection of the error onwards stops when an error is detected.
3.
Power OFF the product.
3 HARDWARE DIAGNOSES
3.2 Performing Diagnosis
3
37
Table of Contents
