Table of Contents
Fixing stoppers of the DIN rail
The following shows the procedure for fixing stoppers of the DIN rail.
This method for fixing DIN rail stoppers is an example. Fix the module in accordance with the manual for the
DIN rail stopper used.
1.
Loosen the screw at the upper part of the stopper (1).
(1)
2.
For the stopper fixed to the left side of the product, turn up the arrow mark printed on the stopper and hitch the tab (2) at
the lower part of the stopper to the DIN rail (3).
(3)
(2)
3.
Hitch the tab at the upper part of the stopper to the upper part of the DIN rail.
4.
Similarly, attach the stopper to the right side of this product.
Fix the stopper on the right side of the product upside down to the stopper of the left side.
5.
Slide the stopper to the end of the base section.
6.
Tighten the screw of the stopper with a screwdriver.
• (Tightening torque: 1.00 to 1.35 N·m)
7.
Check that both stoppers are fixed on the DIN rail securely.
When attaching the DIN rail (1) to a control panel, refer to the dimensions of the stopper (2) below.
(2)
35
(1)
362
378
2 PRODUCT INSTALLATION
(2)
27
2.1 Product Installation
2
Table of Contents
