Replacing A Riser Card - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual
Hide thumbs
Also See for PRIMERGY RX1330 M4:
- Customer service information bulletin (3 pages) ,
- Operating manual (106 pages)
Table of Contents
▶ Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page
85.
▶
"Updating expansion card firmware" on page
▶
"Resuming BitLocker functionality" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer. For more information, see
recovery" on page
▶ If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
9.5.4
Replacing a riser card
Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
▶ Remove the corresponding riser module, see
page
59.
RX1330 M4
Expansion cards and backup units
205.
94.
45.
Upgrade and Maintenance Manual
72.
86.
"Note on network settings
"After replacing or
Hardware: 5 minutes
43.
46.
48.
44.
"Removing a riser module" on
88.
207
Table of Contents
