Table of Contents
Figure 90. Installing the MicroSD card
Next steps
1. Follow the procedure listed in
Optional IDSDM or vFlash module
Removing the optional IDSDM or vFlash module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If you are replacing the IDSDM/vFlash module, remove the MicroSD cards.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Steps
1. Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the
2. Holding the pull tab, lift the IDSDM/vFlash module out of the system.
After working inside your system
Safety instructions
Before working inside your system
System board jumpers and connectors
on page 28.
on page 27.
on page 28.
Installing and removing system components
section.
103
Table of Contents
