Table of Contents
Instructions for use (rev 031121) - En
PROGRAMIX 50 - 100
It is programmed after the final time-delay parameter has been set by pressing the CYCLE key and
FORWARD/REVERSE keys.
The fumes extractor starts operating at the beginning of the heating cycle and stops when the programmed
temperature is reached.
6. USE
Après avoir installé votre four comme indiqué dans le chapitre 4.3 –, actionner l'interrupteur général situé
sur le côté droit.
L'afficheur indique la température (n° 3) et le numéro de programme (n° 2).
After installing your furnace according to the instructions in chapter 4.3 – Start-up, activate the switch
ON/OFF located on the right side of the furnace.
The main display indicates the temperature (No. 3) and the program number (No. 2).
▪ Change the program number
Use the keys
and
.
▪ To visualize and modify the data in a program
Note: during this operation, the program number blinks.
▪ Lock the program
Press
a second time (the program number stops blinking).
▪ Launch the cycle
Press
: all the panel indicators light up.
Each of these indicators will go out at the appropriate time during the heating cycle
Note:
- To move from one stage to the next, use key CYCLE
- To cancel an active cycle, press START/STOP
14
UGIN DENTAIRE
Table of Contents
