Table of Contents
Instructions for use (rev 031121) - En
In programming position:
-
press the key
-
press the key
5.10. START/STOP TOUCH CONTROL
After checking the number of the program selected, press the key START/STOP control
heating cycle. AIl indicators on the panel light up simultaneously.
A second press on START/STOP cancels the cycle.
5.11. CYCLE ADVANCE KEY
During program set-up, the key
During the heating cycle, the key CYCLE is pressed to skip a stage and move on to the next one.
5.12. PROGRAM SELECTION KEY
This key
accesses program selection.
Once
is pressed, program parameters can be entered or modified using the FORWARD/REVERSE
keys. During that time, the program number blinks.
Once the program has been entered, pressing the key
program number then stops blinking.
5.13. INDICATORS
▪
Double
Programs No. 0 to 19 are simple three-stage programs, and the programs No. 20 to 29 are double 6-stage
programs.
While programs No. 20 to 29 are being set up, this indicator goes OFF for stages 1 to 3 and ON for stages 4
to 6.
▪
Calibration
CALIBRATION function is used to adjust the heating temperature in the furnace within a range of -50°C/+40°C,
by increments of 10°C (see chapter 7).
▪
Heating element
This indicator visualizes the electric pulses transmitted to the muffle.
It continues to blink during the heat rise or hold time.
▪
Ventilation
A fumes extractor (available in option) may be connected via the socket located on the back panel of the
PROGRAMIX 50/100 furnaces.
UGIN DENTAIRE
increases the value of the parameter displayed on the screen (No. 3),
decreases that value.
is pressed to choose the parameters to be programmed.
a second time "locks" the program, and the
PROGRAMIX 50 - 100
to start the
13
Table of Contents
