Table of Contents
Display message
Error!!
Failed
Invalid
Requires
subscription
to Caller ID.
Use
rechargeable
battery.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert them into the handset again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
For assistance, please visit http://shop.panasonic.com/support
Cause/solution
R Recording was too short. Try again.
R Someone is using a cellular line or headset. Try
again later.
R The phonebook copy is incomplete (page 70). The
cellular phone is disconnected from the base unit.
Make sure that other Bluetooth devices are not
connected to the cellular phone, and try again.
R Although the unit tried to connect to the cellular
phone or headset, the connection has been failed.
– Someone is using a cellular line or headset. Try
again later.
– Make sure that the cellular phone or headset is
not connected to other Bluetooth devices.
R There is no handset registered to the base unit
matching the handset number you entered.
R The handset is not registered to the base unit.
Register the handset (page 66).
R You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
R A wrong type of battery such as alkaline or
manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 5, 9.
Cause/solution
R Place the handset on the base unit or charger to turn on
the handset.
R Make sure the batteries are installed correctly (page 12).
R Fully charge the batteries (page 13).
R Check the connections (page 12).
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 66).
Useful Information
87
Table of Contents
