Table of Contents
Link to Cell
Auto connection to the Bluetooth
devices (cellular phones)
After pairing, your Bluetooth devices are
connected to the base unit. If you move the
Bluetooth devices out of base unit range, the
Bluetooth devices are disconnected from the
base unit. This feature allows the base unit to
try to reconnect the Bluetooth devices at
regular intervals when it returns within base
unit range. You can set the interval. The
default setting is "1 min".
Important:
R Only 1 Bluetooth device can be used with
the unit at a time, and the base unit loses
its connection from other Bluetooth devices.
To automatically resume the connection to
Bluetooth devices, leave the auto
connection on.
R Some cellular phones lose connection after
usage, please check the specifications of
your cellular phone for more details.
Handset
1
MMENUN#632
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
Note:
R Some cellular phones may ask you if you
accept the connection requirement from the
base unit. In that case, select "Off" in step
2. Check the specifications of your cellular
phone.
Connecting/disconnecting the
cellular phone manually
If you will not be using the paired cellular
phone's link to cell feature temporarily (for
example, you do not want the unit to ring
when your cellular line receives a call), you
can disconnect your cellular phone from the
base unit. If you want to use it again,
reconnect the cellular phone to the base unit.
Note:
R After you disconnect a paired cellular
phone from the base unit manually, it will
automatically be connected to the base unit
in 30 minutes. If you do not use the link to
22
For assistance, please visit http://shop.panasonic.com/support
cell feature anymore, unpair the cellular
phone (page 20).
R A disconnected cellular phone is not
unpaired from the base unit, so pairing it to
the base unit again is unnecessary.
Handset
1
To connect/disconnect:
For CELL 1: MMENUN#6251
For CELL 2: MMENUN#6252
R A long beep sounds.
2
MOFFN
Cellular line only mode (If you do
not use the landline)
If you do not use the landline, we recommend
setting the unit to the cellular line only mode.
The default setting is "Off".
Important:
R If you turn on the "Cell line only
mode", disconnect the telephone line cord
from the base unit. Otherwise the "Cell
line only mode" cannot be activated.
Handset
1
MMENUN#157
2
To turn on:
MbN: "On" a MSELECTN a MbN: "Yes"
a MSELECTN
To turn off:
MbN: "Off" a MSELECTN
Note:
R Once you set this mode, you can use the
following buttons to make cellular calls:
– for the handset, press M
instead of MCELLN (page 24).
– for the base unit, press MSP-PHONEN
without pressing MCELL 1N or MCELL 2N
set for the cellular line selection
(page 23, 31).
R Once you set this mode, the following
features cannot be used:
– Landline features (Incoming ringer
volume, incoming ringer tone, dial mode,
flash time, and line mode)
– Answering system (page 76)
Messages cannot be received.
N or MZN
Table of Contents
