Table of Contents
[STANDBY MODE]
Set the power consumption during standby.
1)
Press as to select [STANDBY MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
Note
f When [ECO] is set, the network function, the terminal, and some RS-232C commands become
inoperable during standby. When [NORMAL] is set, the network function and the terminal can
be used during standby.
f When [ECO] is set, it may take approximately 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
f The [STANDBY MODE] setting does not return to factory default setting even if the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL
USER DATA] is executed.
[QUICK STARTUP]
Set if the [QUICK STARTUP] function is enabled or disabled.
1)
Press as to select [QUICK STARTUP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
f Proceed to Step 3) when [ON] is selected.
3)
Press the button.
f The [QUICK STARTUP] screen is displayed.
4)
Press qw to switch [VALID PERIOD].
f The items will switch each time you press the button.
[30MIN.]
[60MIN.]
[90MIN.]
Note
f [QUICK STARTUP] cannot be set when [STANDBY MODE] is set to [ECO].
f When [QUICK STARTUP] is set to [ON], the power consumption during standby becomes high during the period when the [QUICK
STARTUP] function is valid.
f When [QUICK STARTUP] is set to [ON], the [QUICK STARTUP] function is disabled when the time set in [VALID PERIOD] elapses after the
projector enters the standby mode. The startup time and power consumption will be the same as when [QUICK STARTUP] is set to [OFF].
f When [QUICK STARTUP] is set to [ON], the power indicator blinks red while in the standby mode during the period
when the [QUICK STARTUP] function is valid. The power indicator lights up red when the specified time set in [VALID
PERIOD] elapses after the projector enters the standby mode.
f When [QUICK STARTUP] is set to [ON], the period when the [QUICK STARTUP] function is valid is counted as the projector runtime.
[NO SIGNAL SETTING]
Set the operation of the function when there is no input signal.
[BACKUP INPUT SETTING]
Set the backup function that switches the signal to the backup input signal as seamless as possible when input
signal is disrupted.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when using the network function during standby.
Select this item to reduce power consumption during standby.
Disables the [QUICK STARTUP] function.
Enables the [QUICK STARTUP] function until the specified time set in [VALID PERIOD] elapses after
the projector enters the standby mode. The time until the projection starts after the power is turned on
will be reduced during the period when the [QUICK STARTUP] function is valid.
Sets the time until the [QUICK STARTUP] function is disabled after the projector enters the standby
mode.
Select a desired valid period.
ENGLISH - 139
Table of Contents
