W I R I N G P R O C E D U R E S 1; Remove Terminal Block Cover - GE Fuji Electric MICRO-SAVER AF-300 Instructions Manual

L/4 - 5 horsepower

Hide thumbs Also See for Fuji Electric MICRO-SAVER AF-300:

Instructions manual (44 pages)

Startup manual (127 pages)

Table Of Contents

page of 78

/ 78
Contents
Table of Contents

Table of Contents

S e c t i o n 4

Step 1:

R e m o v e Terminal

Cover screw.

Removing Terminal Block Cover

Remove the terminal

block cover as follows (see Figure 4-l):

2. Press upward on bottom of cover and lift off.

3. See Figure 4-1 for the location of the Main Circuit

Terminal Blockand

WARNING: Some printed circuit boards and Drive com-

ponents may contain hazardous voltage levels. If LED

light CRG 1 on the Base Driver Board is illuminated,

hazardous voltages are present in the Drive circuit boards.

Remove and lock out power before you disconnect or

reconnect wires, and before you remove or replace fuses

and circuit boards. Do not attempt to service the Drive

until the LED indicator has extinguished and the bus

voltaae has discharaed to zero volts.

Mountmg

C o v e r

Heat Smk -

Step 2:

Unlock tabs at the locatlons

remove the terminal cover

Figure 4-1. REMOVING THE FRONT COVER