S2C228: Programming Pendant Cycle Switching; S2C229: Servo On From External Pp Prohibition; S2C230: Programming Pendant Operation When "Io; Is Selected For Remote Mode - YASKAWA DX100 Operator's Manual
For material handling, press tending, cutting, and other applications
Hide thumbs
Also See for DX100:
- Maintenance manual (729 pages) ,
- Operator's manual (520 pages) ,
- Instructions manual (328 pages)
Table of Contents
DX100
8.3.0.26 S2C228: PROGRAMMING PENDANT CYCLE SWITCHING
8.3.0.27 S2C229: SERVO ON FROM EXTERNAL PP PROHIBITION
8.3.0.28 S2C230: PROGRAMMING PENDANT OPERATION WHEN "IO" IS
8
Parameter
8.3 Mode Operation Setting Parameters
This parameter specifies whether cycle switching from the programming
pendant is accepted or not. The specification can be done on the
OPERATING CONDITION window.
0
: Permitted
1
: Prohibited
This parameter specifies whether a servo ON instruction is accepted or
not. More than one instruction can be specified. For example, to permit
the servo ON instruction from an external input only, set "2". In this case,
servo ON instruction from the programming pendant is not accepted. The
specification can be done on the OPERATING CONDITION window.
d7
SELECTED FOR REMOTE MODE
This parameter specifies whether each operation of the following is valid
when "IO" is selected for remote function selection. IO and command are
available for remote function selection: "IO" is set prior to shipping.
"Command" is valid when transmission function (optional) is specified.
d0
d7
8-19
d0
External input prohibited
Programming pendant
DSW
Programming pendant ([SERVO ON READY] key)
valid/invalid
Programming pendant (Enable switch)
Mode switching valid/invalid
Master call valid/invalid
Cycle switching valid/invalid
Start valid/invalid
155507-1CD
: 1 (VALID)
: 2 (VALID)
: 4 (VALID)
: 1 (VALID)
: 2 (VALID)
: 4 (VALID)
: 8 (VALID)
: 16 (VALID)
: 32 (VALID)
RE-CSO-A037
450 of 554
- Quick Links:
- Dx100 Overview
- Programming pendant
Hide quick links:
Table of Contents
