Table of Contents
XNX Universal Transmitter
Fieldbus Options
The Fieldbus Options menu allows configuration of the HART
address or the optional Modbus fieldbus address and baud rate.
Figure 132. Fieldbus Options screen
Select the Fieldbus Options icon to activate the HART/Modbus
screens to allow selection of the protocols to be configured
or changed. If the transmitter is configured without HART or
Modbus, only the installed options will be visible.
Figure 133. HART Options screen
The HART menu provides the ability to select the HART mode.
From the HART screen, use the
HART option, then select
screen where the device address and whether the HART protocol
is active in the unit can be set. To set the address, use the
switches to highlight the number in the top line (between 0 and
63) and use
to select it. Use the
✓
or increaset the value until the desired value appears. Use
select the value and move to the next setting.
Installation and Operation
switches to highlight the
. This displays the HART address
✓
switches to decrease
Figure 134. HART Address and Address Value screens
Use the
switches to move to the HART option and use
to select it. Use the
until the desired option is highlighted. Use
state. See
Local HART Interface
information on available HART modes.
Once the values for the HART address and Mode have been set,
use the
switches to navigate to the 'ü' then select it to save
the changes to the transmitter.
Figure 136. HART Settings Accepted screen
When the Modbus option is available, use the
to
✓
move to the Modbus icon and use
option allows the address and communication baud rate to be
set.
85
switches to scroll through the options
to accept the new
✓
and
HART Protocol
Figure 135. HART Mode screens
to select it. The Modbus
✓
✓
for more
switches to
Hide quick links:
Table of Contents
