Table of Contents
R
PRIMUS
1000 Integrated Avionics System
Step
8
Push and release PB#1 on the display controller. The PFD
blanks and an
step 11.
9
Use the electronic programmable checklist software on the
PC to output the checklist and upload it to the pilot's IAC.
NOTE: If a checklist is already in the IAC, error code 5100 is displayed on
10
When the upload is complete, follow the instructions on the
PC to finish.
NOTE: If the No. 2 IAC needs a checklist upload, pull the No. 2 IAC
11
Pull the appropriate IAC circuit breaker to power down the
IAC.
12
Remove the RS232 cable from the airplane connector.
13
Push in the appropriate IAC circuit breaker to repower the
IAC.
14
When the IAC has powered up, verify that the checklist
can be selected by pushing either the NORM or EMER
button on the MFD controller located in the center
pedestal.
15
Review the checklist for accuracy.
16
The procedure is complete.
Troubleshooting
7-26
X
is displayed. The
the PC. Follow the instructions on the PC.
circuit breaker, move the PC's RS232 cable to the other plug by
the pilot's right rudder pedal. Reset the No. 2 IAC circuit breaker
and repeat steps 3 through 10.
Checklist Upload Procedure
Table 7–14
Procedure
X
remains until after
A28–1146–134
REV 1 Jan/03
- Quick Links:
- The Primus R 1000 Integrated Avionics...
Hide quick links:
Table of Contents
Troubleshooting
