Emerson Rosemount 1057 Quick Start Manual page 2
Single channel transmitter
Hide thumbs
Also See for Rosemount 1057:
- Instruction manual (62 pages) ,
- Instruction manual (66 pages) ,
- Quick start manual (36 pages)
Quick Start Guide
Safety Information
Read this page before proceeding!
Your instrument purchase from Emerson is one of the finest available for your particular
application.These instruments have been designed and tested to meet many national and
international standards.Experience indicates that its performance is directly related to the quailty of
the installation and knowledge of the user in operating and maintaining the instrument.To ensure its
continued operation to the design specifications, personnel should read this Quick Start Guide
thoroughly before proceeding with installation, commissioning, operation, and maintenance of this
instrument.If this equipment is used in a manner not specified by the manufacturer, the protection
provided by it against hazards may be impaired.
•
Failure to follow the proper instructions may cause any one of the following situations to occur:
loss of life, personal injury, property damage, damage to this instrument, and warranty
invalidation.
•
Ensure that you have received the correct model and options from your purchase order. Verify
that this Quick Start Guide covers your model and options. If it does not, call 800 854 8257 or 949
757 8500 to request the correct Quick Start Guide.
•
For clarification of instructions, contact your Rosemount
•
Follow all warnings, cautions, and instructions marked on and supplied with the product.
•
Use only qualified personnel to install, operate, program, and maintain the product.
•
Inform and educate your personnel in the proper installation, operation, and maintenance of the
product.
•
Install equipment as specified in the installation instructions of the appropriate Reference Manual
and per applicable local and national codes. Connect all products to the proper electrical and
pressure sources.
•
Use only factory documented components for repair. Tampering or unauthorized substitution of
parts and procedures can affect the performance and cause unsafe operation of your process.
•
All equipment doors must be closed, and protective covers must be in place unless qualified
personnel are performing maintenance.
WARNING
Risk of electrical shock
Installation and servicing of this product may expose personnel to dangerous voltages.
Equipment protected throughout by double insulation.
Disconnect main power wired to separate power source before servicing.
Do not operate or energize instrument with case open.
Signal wiring within this box must be rated at least 240 V for European mains operation.
Non-metallic cable strain reliefs do not provide grounding between conduit connections. Use
grounding type bushings and jumper wires.
Unused cable conduit entries must be securely sealed by non-flammable closures to provide
exposure integrity in compliance with personal safety and environmental protection
requirements. Unused conduit openings must be sealed with Type 4X or IP66 conduit plugs to
maintain the ingress protection rating (Type 4X).
Electrical installation must be in accordance with the National Electrical Code (ANSI/NFPA-70)
and/or any other national or local codes.
Operate only with front panel fastened and in place.
Safety and performance require that this instrument be connected and properly grounded
through a three-wire power source.
Proper use and configuration is the operator's responsibility.
2
September 2018
™
representative.
Rosemount 1057
