Hitachi CG 31EBS Quick Start Manual

3

6

Throttle wire/stop cord

Remove air cleaner cover. (Fig. 4)

Loosen and remove the screw from the throttle wire holder. (Fig. 6)

Connect the terminals of the stop cords coming out from the engine and shaft. (Fig. 5)

Hook the throttle wire end on the throttle of the carburetor.

Make sure that the throttle lever shown in the Fig.15 is set at the "idle" position.

Put the throttle outer end into the groove, and then cover it with the throttle wire holder and fi x the holder with the screw.

(Fig. 7)

Then, install the cleaner cover.

Fix the protection tube which the stop cords and throttle wire are passing through, on the pipe with the hip pad. Then, as

shown in the fi gure, fi x the protection tube on the pipe and handle with the bands in the bag.

After fi xing, cut off the extra part of the band not to obstruct the operation. (Fig. 3)

NOTE

○ If the protection tube is set apart from the handle or pipe, it will be caught by something during operation and it may

cause serious injury.

Do not set the protection tube apart from the handle or pipe.

○ After assembling the throttle wire, if the wire length does not permit accurate return to the idle position, loosen the

screw in the throttle wire holder and readjust the position of the throttle wire whose outer end is fi xed in the groove.

Tighten the screw in the throttle wire holder to fi x the throttle wire at the position at which idling is enabled.

CG 31EBS/CG 31EBS (L)

How to fi x throttle wire/stop cord

如何安裝油門線 停止線

วิ ธ ี ล ็ อ กสายคั น เร ่ ง/ดั บ เครื ่ อ ง

4

3

7

5

15

C

5