Hard disk drives (HDD) / solid state drives (SSD)
7.3.10.6 Connecting cables
Figure 111: Connecting cables to the SAS backplane (example 4. 3.5-inch HDDs)
Ê Connect the cables to the backplane:
1
If applicable, riser card power cable
2
If applicable, OOB cable
3
SAS cable
4
Power cable
I
For the cable plan, see chapter
7.3.10.7 Concluding steps
Ê Insert all HDD/SSD modules, see section
on page
176.
I
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
"Installing the SAS expander board" on page 251
Ê
"Installing a system fan" on page 266
Ê
"Reassembling" on page 67
Ê
"Connecting the power cord" on page 78
Ê
"Switching on the server" on page 80
Ê
192
"Appendix B" on page
Upgrade and Maintenance Manual
477.
"Installing 3.5-inch HDD modules"
TX1330 M4