Description Of The Parameterizing Cycles; General Information; Setting Additional Parameters - Cycle_Para - Siemens SINUMERIK 840D sl Programming Manual
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Miscellaneous functions
7.2 Measuring cycle support in the program editor (up to measuring cycles SW 5.4)
7.2.4
Description of the parameterizing cycles
7.2.4.1
General information
The individual parameterization cycles of the measuring cycles together with their input
parameters are described below.
The parameter names in the table directly refer to the defining parameters of the measuring
cycle in question in the GUD variables. If no parameter is given, it is a selection field in the
input screen form for particular functions.
7.2.4.2
Setting additional parameters - CYCLE_PARA
With CYCLE_PARA, you can program all generally valid parameters of the measuring
cycles. These parameters do not depend on the individual measuring variant. If an entered
parameter has the value 0, the target parameter is not overwritten, i.e. its previous value is
retained.
Parameter
Parameter
_FA
_VMS
_NMSP
_RF
_PRNUM
_CORA
_TZL
_TMV
_TUL
_TLL
_TSA
_EVNUM
_K
_TDIF
7-14
Type
Value
Meaning
REAL
>0
Measurement path in mm
REAL
≥0
Variable measuring speed
INTEGER
>0
Number of measurements at the same location
REAL
>0
CYCLE979 only:
Feedrate in circular-path programming
INTEGER
>0
Probe number
REAL
Only if mono probe is used:
Offset angle position
REAL
≥0
Tolerance range for zero offset
REAL
≥0
Select range for offset with mean value calculation, greater
than _TZL
REAL
Upper tolerance range workpiece, oversize acc. to drawing
REAL
Lower tolerance range workpiece, undersize acc. to drawing
REAL
>0
Safe area for measuring result
INTEGER
≥0
Number of empirical value memory that is calculated
INTEGER
Weighting factor for mean value calculation
≥1
REAL
>0
Tolerance range for dimensional difference check
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles
Table of Contents
