User Enrollment In Database - Safran MorphoAccess SIGMA Series Administration Manual
Hide thumbs
Also See for MorphoAccess SIGMA Series:
- Quick user manual (33 pages) ,
- Installation manual (81 pages) ,
- Administration manual (478 pages)
Table of Contents
MorphoAccess® SIGMA Series - Administrator Guide
Terminal Configuration through Webserver
User Enrollment in Database
This feature of MorphoAccess® SIGMA Family Series terminal allows an administrator to enroll
new users in the terminal. The user information such as name, biometric data (i.e. fingerprint),
User ID and PIN, access rights, etc. are entered and stored in the terminal database.
Terminal will allow access to the user by comparing the data provided by the user at access
request, against the data provided by the user at the time of enrollment.
Access Path
User Management > User Enrollment > Enrollment mode > DB Only
Pre-requisites
If terminal is in Legacy L1 mode, then enrolment of users can be done only if Secure
Admin station is equipped with a MorphoSmart™ MSO biometric sensor
The data of the users enrolled in MA5G mode cannot be exported in L1 systems
Screens & Steps
1. Enter User Identifier (User ID). Numeric value up to 24 digits.
NOTE:
Wiegand protocol for User ID doesn't support special characters such as "*" and
"#", then is not recommended to insert these characters in the User ID value.
There is a configuration key, misc.user_id_edit, to make user ID field read only.
With this parameter, the user id can be extracted from the Smartcard and restrict
user to edit this field. misc.user_id_edit is accessible from PC application or Web
Server.
2. Under Enrolment Information screen, an administrator need to enter several
parameters:
2017_2000025464-v03
July 17
Figure 293: Adding user information
This document and the information therein are the property of Morpho. They must not
be copied or communicated to a third party without the prior authorization of Morpho
315
Table of Contents
