Table of Contents
4 SETPOINT PROGRAMMING
S CLEAR DATA
S [ENTER] for more
These commands may be used to clear various historical data.
•
CLEAR LAST TRIP DATA: Clears the last trip data.
•
RESET MWH AND MVARH METERS: Resets the MWh and Mvarh metering to zero.
•
CLEAR PEAK DEMAND DATA: Clears the peak demand values.
•
CLEAR RTD MAXIMUMS: All maximum RTD temperature measurements are stored and updated each time a
new maximum temperature is established. This command clears the maximum values.
CLEAR ANALOG I/P MIN/MAX: The minimum and maximum analog input values are stored for each analog
•
input. These minimum and maximum values may be cleared at any time.
•
CLEAR TRIP COUNTERS: There are counters for each possible type of trip. This command clears these
counters.
PRESET DIGITAL COUNTER: When one of the assignable Digital Inputs is configured as Counter, this com-
•
mand presets the counter. If the counter is of the incrementing type, setting the preset value to 0 effectively
clears or resets the counter.
•
CLEAR EVENT RECORD: The event recorder saves the last 40 events, automatically overwriting the oldest
event. If desired, this command can clear all events to prevent confusion with old information.
GE Power Management
ð
CLEAR LAST TRIP
ENTER
DATA: No
ESCAPE
RESET MWh and Mvarh
ESCAPE
METERS: No
MESSAGE
CLEAR PEAK DEMAND
ESCAPE
DATA: No
MESSAGE
CLEAR RTD
ESCAPE
MAXIMUMS: No
MESSAGE
CLEAR ANALOG I/P
ESCAPE
MIN/MAX: No
MESSAGE
CLEAR TRIP
ESCAPE
COUNTERS: No
MESSAGE
PRESET DIGITAL
ESCAPE
COUNTER: No
MESSAGE
CLEAR EVENT
ESCAPE
RECORDER: No
MESSAGE
469 Motor Management Relay
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
4.2 S1 469 SETUP
4.2.7 CLEAR DATA
4
4-9
Table of Contents
