Auto-Manual Switch Instruction, continued
AUTO-MANUAL
Switch
Step
1
Remove AC power to the actuator.
2
Remove four screws and the terminal panel cover from the actuator. See Figure 1
3
Remove two screws and pull out the terminal panel from the actuator case.
NOTE: It may be necessary to loosen the external cable entrance on the side of the actuator case to
gain greater access to the AUTO-MANUAL switch location behind the terminal panel.
Page 2 of 5
Terminal Panel
Figure 1 AUTO-MANUAL Switch Location
Table 1 AUTO-MANUAL Switch Installation Procedure
Action
Procedure continued on next page
⇒
62-86-33-26
