Table of Contents
Installing or Replacing Modules, Fan Trays, and Power Supplies
If the version of NX-OS is not the same as you intended to use, copy the previously saved images from the
Note
USB drive in usb1 to bootflash: and perform an upgrade to the appropriate version. For more information,
see the
Step 16
Copy the TAR archive containing the license files from the usb1 drive to bootflash:, extract the archive, and install the
licenses by using the copy, tar extract, and install license commands. Repeat the install license command for each
extracted license file.
switch(config)# copy usb1:licenses_archive_file_name.tar bootflash:
switch(config)# tar extract bootflash:licenses_archive_file_name.tar to bootflash:
switch(config)# install license bootflash:licenses_archive_file_name.lic
The tar extract command requires that the TAR file be located in bootflash: or volatile:.
Note
Step 17
Make sure that all I/O modules are online and that the standby supervisor is in ha-standby mode by using the show
module command.
switch(config)# show module
switch(config)# show module
Mod Ports Module-Type
--- ----- ----------------------------------- ------------------ ---------------
5
0
Supervisor module-3
6
0
Supervisor module-3
7
24
10/40 Gbps Ethernet Module
...
Step 18
Restore the previously saved configurations by using the copy command to copy the configuration file in the USB
drive to the running configuration.
switch(config)# copy usb1:configuration_file_name running-config
Note
If the imported configuration file includes configurations for Fabric Extenders (FEXs) and those modules
are not up yet, you will see error messages for that. If that happens, we recommend that you run the FEX
configuration again after the FEX modules come online. You can verify the status of the FEX modules and
for the associated server-facing interfaces by using the show fex and show interface brief commands.
If you have not inserted the standby supervisor module until now, do not insert it during this step. Instead,
Note
wait until you complete this procedure before installing the standby supervisor module.
Step 19
Save the configuration in the startup configuration by using the copy running-config startup-config vdc-all command.
switch(config)# copy running-config startup-config vdc-all
Installing or Replacing an I/O Module
Before you begin
• You must follow ESD protocols, including the following:
OL-31330-01
Cisco Nexus 7000 Series NX-OS Software Upgrade and Downgrade
• You must wear a grounded ESD wristband (or other personal grounding device) whenever you
handle the electronic modules outside the grounded chassis.
Installing or Replacing an I/O Module
Model
Status
N77-SUP3E
active *
N77-SUP3E
ha-standby
N77-M324FQ-25L
ok
Cisco Nexus 7706 Hardware Installation Guide
Guide.
89
Table of Contents
