Table of Contents
5
Getting started
This section is intended to provide a generic guide for configuring SI-PROFIBUS with a
master controller. Figure 5-1 is intended as a basic guide, but it does detail the stages
that are required to achieve a functioning network. It is recommended that all of this
chapter is read, before attempting to configure a system.
Due to the large number of PLCs/masters that support PROFIBUS-DP, only generic
NOTE
details can be provided. Support is available through your supplier or local Control
Techniques Drive Centre.
Before contacting your supplier or local Control Techniques Drive Centre for support,
NOTE
please read of this manual to check that you have configured all parameters correctly.
Before calling, please ensure you have the following information readily to hand:
•
•
•
18
A list of all parameters in SI-PROFIBUS.
The drive firmware version (see the relevant Drive User Guide).
The SI-PROFIBUS firmware version.
Unidrive M SI-PROFIBUS User Guide
Issue Number: 3
Hide quick links:
Table of Contents
