Table of Contents
EA6
Cycle immediately blocked if a not correct tachometric signal is identified for at least 3
Checks to perform:
Open the door and
manually check if
the drum turns
easily.
Is the drum
blocked?
YES
Replace the drum flap
and restart the
diagnostic cycle to
check for further alarms.
Check/replace the wiring and restart the diagnostic
cycle to check for further alarms.
07-2010 SOI/DT-mdm FCPD-dp Quality-fz
EA6: Drum flap faulty (top-loaders)
Check that all the connectors are inserted correctly
Measure across the
terminals of the wiring
NO
connector J2-3 and
J2-4.
Are the values (Ω) of
the tachometric
generator correct?
(see page. 59
- Step 4, phase "A").
YES
Measure across the
same terminals of the
wiring connector (J2-3
and J2-4) and the
structure of the
appliance.
Is there any leakage?
– (see fig. 6) –
YES
seconds
Detach the connector
from the motor and
NO
measure (Ω) the coil
of the tachometric
generator
– see fig. 11 – Is the
value correct?
(see page. 59
- Step 4, phase "A").
YES
Check/replace the wiring and restart the
diagnostic cycle to check for further alarms.
Check for the
positioning of the
NO
tachometric
generator.
Is it correct?
– (see fig. 12) –
YES
Replace the main circuit board and restart the
diagnostic cycle to check for further alarms.
90/121
Replace the
motor or the
NO
tachometric
generator and
restart the
diagnostic cycle
to check for
further alarms.
Replace the
motor/ generator
NO
and restart the
diagnostic cycle
to check further
If there are traces of burning on the
circuit board, refer to pages
EA6
alarms.
119-120
599 70 99-00
Hide quick links:
Table of Contents
