Grinder Assembly - Miele CVA 610 Technical Information

CVA 610/CVA 615 Coffee Systems

passing through the water pump is registered via the flow meter and monitored by

the electronic.

After most of the 800 milliliters is calculated as being used, the display shows, "Fill

water tank." To prevent the water pump from running dry, approximately 90 to 200

milliliters (3 to 7 ounces) of water remains in the tank.

In service mode, the top line of the display will show the switches that have been

activated. A "7" is displayed when the water tank is installed and filled with water.

Refer to Section 6.2.

4.9

The grinding grade depends on the gap between the grinding cone (Figure 4-12,

Item 1) and the grinding ring (Figure 4-12, Item 2).

The gap is set via the adjustment lever (Figure 4-12, Item 5) on the adjustment ring

(Figure 4-12, Item 3). The smaller the gap, the finer the grind of coffee will be.

Warning!

To avoid damage to the grinder, the grinder should only be adjusted in

small steps.

Figure 4-11: Grinder Assembly

For an exploded view of the complete grinder assembly, see Figure 5-48.

Technical Information

1 Grinding cone

2 Grinding ring

3 Adjustment ring

4 Intake worm gear

5 Adjustment lever

6 Handle

25