Replacing Hdd - Siemens SIMATIC IPC477D Operating Instructions Manual
Hide thumbs
Also See for SIMATIC IPC477D:
- Operating manual (54 pages) ,
- Quick install manual (2 pages) ,
- Operating instructions manual (210 pages)
Table of Contents
Maintaining and servicing your device
7.4 Installing and removing hardware
7.4.1.5
Replacing HDD
This chapter applies to devices with hard disk drive.
Requirement
● The device is disconnected from the power supply.
● The device is open, see the section "Opening the built-in unit (Page 133)".
● Hard disk drive
● T10 screwdriver
Procedure
Removal
1. Remove the marked screws.
2. Carefully remove the base plate with the
hard disk fastened to it.
3. Remove the connector in the direction of
the arrow.
4. Detach the hard disk from the base plate.
Remove the four screws that connect the
hard disk and the base plate.
Installation
Note
Screws in various lengths
This procedure involves screws of various lengths:
• Screws to fasten the SSD to the hard disk holder (short screws)
• Screws to fasten the hard disk holder to the device (long screws)
Make sure you use the correct screws for each operation.
For installation, follow these steps in reverse and close the device.
160
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 11/2016, A5E31347228-AF
- Quick Links:
- Product Description
Hide quick links:
Table of Contents
