Table 1.3 Status And Meanings Of Each Led (Controller) - Fujitsu ETERNUS DX100 S4 Basic Operation Manual
Hybrid
Hide thumbs
Also See for ETERNUS DX100 S4:
- Design manual (207 pages) ,
- Site planning manual (57 pages) ,
- Configuration manual (78 pages)
Table of Contents
Chapter 1
Component Names and LED Names
1.1
Controller Enclosures
13. LINK/FAULT LED
14. LAN ACT LED
15. LAN LINK LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1.3 Status and Meanings of Each LED (Controller)
LED name
IDENTIFY/BBU FAULT
DI (OUT) LINK/FAULT
READY/FAULT
MASTER
CA FAULT
LINK/FAULT
LAN ACT
LAN LINK
■
Host Interfaces
A host interface is a board that has interface ports to connect a controller to the server.
There are seven types of host interfaces: FC 16Gbit/s, FC 8Gbit/s, iSCSI 10Gbit/s, iSCSI 1Gbit/s, SAS 12Gbit/s,
Ethernet 10Gbit/s, and Ethernet 1Gbit/s.
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
LED status
Meaning
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installation
(blinks blue)
location of the controller is identified.
The battery is in error status.
(amber)
The link between the DI (OUT) port and the destination port has
(green)
been established.
•
(amber)
•
The ports to connect the cables are indicated. This occurs while a
(blinks amber)
drive enclosure is being added.
The controller is in normal status.
(green)
An error has occurred during startup.
(blinks green)
•
(amber)
•
(blinks amber)
The controller is set as a Master CM.
(green)
The host interface is in error status.
(amber)
The link between the host interface port and the destination port
(green)
has been established.
The host interface port is in error status.
(amber)
Data is being sent or received via the LAN port.
(blinks green)
The link between the LAN port and the destination has been es-
(green)
tablished.
22
Copyright 2017 FUJITSU LIMITED
The link between the DI (OUT) port and the destination port is
in error status.
The ports to remove the cables between enclosures from are in-
dicated. This occurs while a drive enclosure is being added.
The controller is performing the initial setup after the power is
turned on.
The controller is in error status.
P3AM-7662-09ENZ0
- Quick Links:
- Replacing Batteries
Hide quick links:
Table of Contents
