Eternus Dx100 S4/Dx200 S4 Components (Rear); Table 1.2 Status And Meanings Of Each Led (Drive (Controller Enclosure)) - Fujitsu ETERNUS DX100 S4 Basic Operation Manual
Hybrid
Hide thumbs
Also See for ETERNUS DX100 S4:
- Design manual (207 pages) ,
- Site planning manual (57 pages) ,
- Configuration manual (78 pages)
Table of Contents
Chapter 1
Component Names and LED Names
1.1
Controller Enclosures
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1.2 Status and Meanings of Each LED (Drive (Controller Enclosure))
LED name
DRIVE READY
DRIVE FAULT
1.1.4
ETERNUS DX100 S4/DX200 S4 Components (Rear)
This section describes the controllers and the power supply units in the rear of the controller enclosure for the
ETERNUS DX100 S4/DX200 S4.
■
Controllers
The controller contains a CPU, system memory, Battery Backup Unit (BBU), host interfaces, drive interface
(DI) ports, and LAN ports. The controller controls all operations in the ETERNUS DX.
Two types of host interfaces, which are shown in
Table 1.3
shows the status and meanings of each LED.
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
LED status
Meaning
The drive is in normal status.
(green)
(blinks green)
•
(amber)
•
Figure
20
Copyright 2017 FUJITSU LIMITED
The drive is in error status.
The LED light up operation was performed from the ETERNUS
CLI command line in order to identify the drive location.
1.10, can be installed in the controller.
P3AM-7662-09ENZ0
- Quick Links:
- Replacing Batteries
Hide quick links:
Table of Contents
