Table of Contents
6
BUFFER MEMORY
6.14
CH1 Level Trigger Condition Setting (Un\G35)
Conditions for using level triggers is set during the logging facility use. (Refer to Section
4.2.7 (3).)
For information on the buffer memory for CH2 or later, refer to Section 6.1 (1).
(1) Setting method
Setting
Description
value
0
Disable
A hold trigger occurs only when CH1 Logging hold request (Y1) is set to on.
When the amount of trigger
data exceeds the trigger
1
Above
setting value, a level trigger
occurs.
When the amount of trigger
data falls below the trigger
2
Below
setting value, a level trigger
occurs.
When the amount of trigger
Pass
data reaches to the trigger
3
through
setting value, a level trigger
occurs.
6
- 17
6.14 CH1 Level Trigger Condition Setting (Un\G35)
(a) Set a condition for using a level trigger by using the buffer memory.
Table 6.16 Setting range of CH1 Level trigger condition setting (Un\G35)
If either of the following (1) or (2) is satisfied, a level trigger will occurs.
(1) If the condition "Current value of CH1 Trigger data (Un\G36) > CH1 Trigger
(2) If the condition "Current value of CH1 Trigger data (Un\G36) < CH1 Trigger
(b) Set Operating condition setting request (Y9) to on to activate the setting. (Refer to
Section 5.2.2 (3).)
Timing of occurrence of level trigger
CH1 Trigger data (Un\G36) > CH1 Trigger setting value (Un\G37)
Trigger data
Trigger
setting value
CH1 Trigger data (Un\G36) < CH1 Trigger setting value (Un\G37)
Trigger data
Trigger
setting value
setting value (Un\G37)" is satisfied under the condition "Previous value of CH1
Trigger data (Un\G36)
CH1 Trigger setting value (Un\G37)"
setting value (Un\G37)" under the condition "Previous value of CH1 Trigger
data (Un\G36)
CH1 Trigger setting value (Un\G37)"
Trigger data
Trigger
setting value
Trigger occurrence (1)
Trigger occurrence
Time
Trigger occurrence
Time
Trigger data
Trigger occurrence (2)
Trigger
setting value
Time
Time
- Quick Links:
- A/D Conversion Methods
- Wiring
Hide quick links:
Table of Contents
Troubleshooting
