Chapter 12 - Serial Programming Commands; Conventions; Menu Command Syntax - Honeywell Xenon 1900 User Manual
Area-imaging scanners
Hide thumbs
Also See for Xenon 1900:
- User manual (360 pages) ,
- Quick start manual (21 pages) ,
- User manual (266 pages)
Table of Contents
CHAPTER
1 2
SERIAL PROGRAMMING
COMMANDS
The serial programming commands can be used in place of the programming bar
codes. Both the serial commands and the programming bar codes will program the
scanner. For complete descriptions and examples of each serial programming
command, refer to the corresponding programming bar code in this manual.
The device must be set to an RS232 interface (see
mands can be sent via a PC COM port using terminal emulation software.
Conventions
The following conventions are used for menu and query command descriptions:
parameter
[option]
{Data}
bold
Menu Command Syntax
Menu commands have the following syntax (spaces have been used for clarity
only):
Prefix [:Name:] Tag SubTag {Data} [, SubTag {Data}] [; Tag SubTag {Data}] [...] Storage
Prefix
:Name:
Xenon/Granit User Guide
A label representing the actual value you should send as part of a
command.
An optional part of a command.
Alternatives in a command.
Names of menus, menu commands, buttons, dialog boxes, and win-
dows that appear on the screen.
Three ASCII characters: SYN M CR (ASCII 22,77,13).
This command is only used with cordless devices. It is used to spec-
ify whether you're communicating with the base or the scanner. To
send information to the scanner (with the base connected to host),
use :Xenon: The default factory setting for a Xenon scanner is Xenon
page
16). The following com-
259
- Quick Links:
- Connect with Usb
Hide quick links:
Table of Contents
Troubleshooting
