Settings For Various Host Accesses - Fujitsu ETERNUS DX80 S2 Cli User's Manual
Disk storage systems
Hide thumbs
Also See for ETERNUS DX80 S2:
- User manual (186 pages) ,
- User's manual & installation instructions (147 pages) ,
- Overview (97 pages)
Table of Contents
Appendix D Basic Setting Examples
D.2 Settings for Various Host Accesses
5
Map a volume with LUNs and create a LUN group named AG001.
CLI> create lun-group -name AG001 -volume-name v0,v1 -lun 10-11
In this example, volumes are mapped as follows:
•
Volume v0 is paired with LUN 10.
•
Volume v1 is paired with LUN 11.
6
Set the relationship between port group PG0001, LUN group AG001, and host group HG01.
CLI> set host-affinity -port-group-name PG0001 -ag-name AG001 -host-group-name HG01
D.2
Settings for Various Host Accesses
This section describes host access settings that are not covered in
741).
An outline of these settings is provided below.
•
Specifying a host and performing mapping (host affinity mode)
Mapping (Host Affinity Mode)" (page
(1) Enable the host affinity mode of the host interface port.
(2) Set the parameter that controls the host interface port.
(3) Register a host that is used to identify the HBAs (Host Bus Adapter).
(4) Create an affinity group.
(5) Set the relationship between the host, host interface ports, and affinity group.
•
Specifying a port group and performing LUN mapping
Mapping" (page
(1) Set the parameter that controls the host interface port.
(2) Set a host response.
(3) Create a port group.
(4) Create an affinity group.
(5) Set the relationship between the port group, affinity group, and host response.
743))
744))
742
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
"D.1.2 Host Access Setting Procedure" (page
("D.2.1 Specifying a Host and Performing
("D.2.2 Specifying a Port Group and Performing LUN
End of procedure
P2X0-1030-09ENZ0
- Quick Links:
- Accessing Cli
Hide quick links:
Table of Contents
