Sony SRW-5000 Operation Manual page 149
Hd digital videocassette recorder
Hide thumbs
Also See for SRW-5000:
- Maintenance manual (438 pages) ,
- Operation manual (202 pages) ,
- Installation manual (54 pages)
Table of Contents
Item number
Item
303
POSTROLL TIME
304
VAR SPEED RANGE
FOR
SYNCHRONIZATION
305
EDIT FIELD select
306
SYNCHRONIZE
310
EDIT PRESET
REPLACE
CHANNEL SELECT
Sub item
REPLCE CH SEL
REPLCE TR1
REPLCE TR2
REPLCE TR3
REPLCE TR4
REPLCE TR5
REPLCE TR6
REPLCE TR7
REPLCE TR8
REPLCE TR9
REPLCE TR10
REPLCE TR11
REPLCE TR12
Setting
Function
0 sec
This sets the tape running time after passing the OUT point
(postroll time) in automatic editing.
The range is from 0 to 30 seconds, in steps of 1 second.
[5 sec]
30 sec
[-1 to +2]
Specifies the variable tape speed range when the variable
–1.15 to +2.45
speed playback is executed by a remote control unit
connected to the REMOTE 1-IN(9P) connector.
–1 to +2: –1 to +2 times normal tape speed
–1.15 to +2.45: –1.15 to +2.45 times normal tape speed
Note
When an editing control unit such as BVE-9100 is
connected for DT editing, select "–1.15 to +2.45".
[1F]
Selects the start timing for editing when performing tape
2F
editing.
1F/2F
1F: Start editing from field 1 and end on field 2.
2F: Start editing from field 2 and end on field 1.
1F/2F: Following received timing commands.
Note
When the system frequency of this unit is PsF mode, the
unit always operates with the 1F setting.
[accurate]
When this unit is used as a controller for editing control of
rough
another VTR connected through a 9-pin remote cable, this
off
selects whether or not to carry out phase synchronization
of the two VTRs, and also the editing accuracy when
carrying out synchronization.
accurate: Editing is carried out with an accuracy of ±0
rough: Editing is carried out with an accuracy of ±1 frame.
off: Synchronization is not carried out.
Specifies the channel of the edit preset command to be
assigned with the edit preset settings for each channel.
[disable]
disable: The setting in this menu is disabled and the
enable
enable: The setting in this menu is enabled.
CH1 to [CH1] to CH12
The edit preset setting of this track turns on or off according
to CH12 to the specified channel of the edit preset
CH1 to [CH2] to CH12
command.
CH1 to [CH3] to CH12
CH1 to [CH4] to CH12
CH1 to [CH5] to CH12
CH1 to [CH6] to CH12
CH1 to [CH7] to CH12
CH1 to [CH8] to CH12
CH1 to [CH9] to CH12
CH1 to [CH10] to CH12
CH1 to [CH11] to CH12
CH1 to [CH12]
frames.
settings in the REPLACE MODE menu and the
ANALOG REPLACE menu are used.
149
Menu List
Table of Contents
