Fujitsu ETERNUS DX60 S2 User Manual page 9
Hide thumbs
Also See for ETERNUS DX60 S2:
- User manual (131 pages) ,
- Maintenance manual (55 pages) ,
- Hardware and software installation manual (36 pages)
Table of Contents
Cable Connection
S T E P
Various cables need to be connected to the rear of the ETERNUS DX Disk storage system.
●
Point
●
The cables should never be bent, twisted or pulled.
IMPORTANT
LAN Cable (For Operation Management)
Connect a LAN cable (for operation management) to each MNT port.
Cable
-Installation- "4.1 LAN Cable Connection (For Operation Management)"
Host Interface Cable
Connect a host interface cable to each of these ports.
Cable
FC
●
iSCSI
●
SAS
●
-Installation- "4.2 Host Interface Connection"
FUJITSU Storage ETERNUS DX60 S2 Disk storage system Read Me First
To help with cable management and prevent incorrect connection, attach labels to the cables and
make a note of connection origins and destinations.
This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for
single controller type.
Rear view
Controller (CM#0)
Rear view
Copyright 2014 FUJITSU LIMITED
Controller (CM#1)
The MNT port
is on the right side.
Port#0 (left), Port#1 (right)
Port#0 (left), Port#1 (right)
Port#0 (left), Port#1 (right)
9
Controller
Enclosure
Controller
Enclosure
Controller
Enclosure
Controller
Enclosure
P3AM-5542-07EN
Table of Contents
