Removing A Hard Drive From A Drive Bay - HP 8200 Elite Series Maintenance And Service Manual
Hide thumbs
Also See for 8200 Elite Series:
- Quickspecs (77 pages) ,
- Hardware reference manual (31 pages) ,
- Product end-of-life disassembly instructions (12 pages)
Table of Contents
b.
If your are installing a media card reader, connect the USB cable to the USB system board
connector labeled MEDIA.
Figure 7-19
8.
If installing a new drive, connect the opposite end of the data cable to the appropriate system
board connector.
NOTE:
drive to the white SATA connector on the system board labeled SATA2. Connect the data cable
for a second optical drive to the black SATA connector on the system board labeled ESATA. If
the ESATA connector is already populated, connect the second optical drive to the light blue
connector (8200 Elite models) or the white connector (6200 Pro models) labeled SATA1.
Refer to
connectors.
9.
Replace the front bezel and computer access panel.
10.
Reconnect the power cord and any external devices, then turn on the computer.
11.
Lock any security devices that were disengaged when the access panel was removed.
Removing a Hard Drive from a Drive Bay
NOTE:
Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Disconnect the power cable and data cable from the back of the hard drive.
144 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis
Connecting the Media Card Reader USB Cable
If you are installing a new SATA optical drive, connect the data cable for the first optical
System Board Connections on page 128
(Computer Access Panel on page
for an illustration of the system board drive
(Preparation for Disassembly on page
126)
125)
- Quick Links:
- Computer System Components
Hide quick links:
Table of Contents
