Installing A 5.25-Inch Drive Into A Drive Bay - HP 8200 Elite Series Maintenance And Service Manual
Hide thumbs
Also See for 8200 Elite Series:
- Quickspecs (77 pages) ,
- Hardware reference manual (31 pages) ,
- Product end-of-life disassembly instructions (12 pages)
Table of Contents
No.
Guide Screw
1
Black M3 Metric Screws
2
Silver 6-32 Standard Screws
3
Silver and Blue 6-32 Isolation Mounting Screws
CAUTION:
If you are inserting or removing a drive, shut down the operating system properly, turn off the
computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby
mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,
avoid touching the connector. For more information about preventing electrostatic damage, refer to
Electrostatic Discharge Information on page
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and
label the package "Fragile: Handle With Care."
Installing a 5.25-inch Drive into a Drive Bay
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the front bezel
4.
If you are installing a drive in a bay covered by a bezel blank, remove the bezel blank. See
Blanks on page 77
To prevent loss of work and damage to the computer or drive:
(Front Bezel on page
for more information.
Device
5.25-inch Drives
3.5-inch Hard Drive in the Top Drive Bay (Bay 4)
3.5-inch Hard Drives in the Middle and Bottom Drive Bays
(Bays 5 and 6)
60.
(Preparation for Disassembly on page
(Computer Access Panel on page
75).
73).
74).
Bezel
Drives
93
- Quick Links:
- Computer System Components
Hide quick links:
Table of Contents
