Table of Contents
Problems encountered during installation
Unpacking
Description
Some parts appear to be missing or
damaged.
The screws or mounting hardware are not suitable for the server
Description
Additional parts may be required for
fitting the tape drive into the server.
It is unclear which SCSI ID to use
Description
It is uncertain which ID numbers are
available.
How should the SCSI bus be configured?
Description
Correct configuration of the SCSI bus
with multiple drives can be a complex
area and more help may be required.
Daisy chaining devices is not generally
recommended.
How should the SCSI bus be terminated?
Description
It is unclear if the bus is already
terminated or where an additional
terminator should be placed.
Further information
Contact your vendor if any parts need replacing.
Further information
The HP StorageWorks Ultrium internal tape drive
will fit into most servers without the need for
additional hardware other than that originally
shipped with your system. If additional parts are
required, or the original parts have been lost,
contact your server vendor. See "Step 4: Attach
mounting hardware" on page 15.
Further information
Use HP Library & Tape Tools (see page 34) to
provide information on your current SCSI settings.
The HP StorageWorks Ultrium drive has its SCSI ID
set to 3 by default. This should be left unchanged
unless this number is already in use. Full
instructions on how to change the SCSI ID are
given on page 11.
Further information
Refer to the instructions in this guide or your
supplier for further details.
Further information
Both ends of a SCSI bus must be terminated.
Typically, when connecting an internal drive to the
ribbon cable already inside your server then both
the host bus adapter and the end of the ribbon
cable will already be terminated and no further
action is required.
39
- Quick Links:
- Understanding the Leds
Hide quick links:
Table of Contents
